Installation Procedure
- Remove the caps from fuel feed tank pipe and fuel feed pipe.
- Install the fuel feed pipe and secure with the rear fuel pipe clip.
- Connect the fuel tank feed pipe connector (1) to the fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel pressure sensor wiring harness plug (2).
- Install the fuel feed pipe (1) to lower bulkhead and underbody.
- Close the 4 fuel pipe clips (2).
- Rotate the right frame reinforcement to its original position.
- Install the exhaust front hanger bracket bolts (3).
- Install the frame reinforcement bolt (2).
- Tighten the NEW exhaust front hanger bracket bolt (3) to 22 Y (16 lb ft).
- Tighten the NEW frame reinforcement bolt (2) to 60 Y (44 lb ft).
- Tighten the drivetrain and front suspension frame bolt (1) to 160 Y (118 lb ft).
- Lower the vehicle.
- Clip the fuel feed pipe to the bulk head retainer clip (2).
- Clip the fuel feed pipe (1) to the retainer clip (4).
- Connect the fuel feed pipe connector (3) to the fuel injector rail. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Close the hood.
CAUTION:
Refer to Fastener Caution .
CAUTION:
Refer to Torque-to-Yield Fastener Caution .