LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Cruze LTZ >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls/Fuel - 1.4L - Repair Instructions >> Repair Instructions >> Fuel Feed Pipe Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING:

Refer to Gasoline/Gasoline Vapors Warning .

  1. Open the hood.
  2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Relieve the fuel pressure. Refer to Fuel Pressure Relief .
    4. Fig 1: Fuel Feed Pipe
    GM2373056Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the fuel feed pipe connector (3) from fuel injector rail. Refer to Metal Collar Quick Connect Fitting Service .
  5. Unclip the fuel feed pipe (1) from the retainer clip (4).
  6. Close the fuel feed pipe connector with a suitable cap.
  7. Unclip the fuel feed pipe from the bulk head retainer clip (2).
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    9. Fig 2: Front Exhaust Hanger Bracket And Bolt
    GM2538049Courtesy of GENERAL MOTORS COMPANY
  9. Remove and DISCARD the exhaust front hanger bracket bolt (3).
  10. Remove and DISCARD the frame reinforcement bolt (2).
  11. Loosen the drivetrain and front suspension frame bolt (1).
    12. Fig 3: Right Frame Reinforcement
    GM2538051Courtesy of GENERAL MOTORS COMPANY
  12. Rotate the right frame reinforcement (1) to a position shown to get access to the fuel pipes.
    13. Fig 4: Fuel Feed Pipe And Clips
    GM2191622Courtesy of GENERAL MOTORS COMPANY
  13. Open the 4 fuel pipe clips (2).
  14. Remove the fuel feed pipe (1) from lower bulkhead and underbody.
    15. Fig 5: Fuel Tank Feed Pipe Connector
    GM2373058Courtesy of GENERAL MOTORS COMPANY
  15. Disconnect the fuel tank feed pipe connector (1) from the fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service .
  16. Close the fuel feed pipe and fuel tank feed pipe with suitable caps.
  17. Disconnect the fuel pressure sensor wiring harness plug (2).
  18. Open the rear fuel pipe clip and remove the fuel feed pipe.
scientia non olet · About LEMON Manuals