LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Impala LS, Gas >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L - Repair Instructions >> Repair Instructions >> Fuel Pump Flow Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Fuel Pump Flow Control Module And Bolts
    GM2656312Courtesy of GENERAL MOTORS COMPANY
  1. Install the fuel pump flow control module (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the fuel pump flow control module bolts (1) and tighten to 6.5 N.m (58 lb in).
    3. Fig 2: Fuel Pump Flow Control Module Bracket And Nuts
    GM2656289Courtesy of GENERAL MOTORS COMPANY
  3. Install the fuel pump flow control module and bracket (2).
  4. Install the fuel pump flow control module bracket nuts (1) and tighten to 5 N.m (44 lb in).
  5. Connect the electrical connector.
  6. Install the rear compartment side trim panel right side. Refer to Rear Compartment Side Trim Replacement - Right Side
  7. If replacing, reprogram the module. Refer to Control Module References
scientia non olet · About LEMON Manuals