LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Orlando LS, Automatic Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> Fuel Pump Flow Control Module Programming and Setup >> Fuel Pump Control Module Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pump Control Module Programming

To program and setup an existing or new replacement fuel pump control module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) .
  2. On the SPS Supported Controllers screen, select K27 Fuel Pump Control Module - Programming and follow the on-screen instructions.

If the fuel pump control module fails to accept the program, verify all scan tool and fuel pump control module connections are secure.

NOTE:

After programming is completed, perform the following to avoid future misdiagnosis:

  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. Clear all DTC's from all modules.
scientia non olet · About LEMON Manuals