LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Orlando LS, Automatic Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Programming and Setup >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inflatable Restraint Sensing and Diagnostic Module Programming and Setup: Notes

The inflatable restraint sensing and diagnostic module (SDM) must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the SDM will not control all of the vehicle features properly.

Ensure that the following conditions exist in order to prepare for SDM programming:

  1. The battery is fully charged.
  2. The MDI data link connectors are secure.
  3. The scan tool is loaded with the most current software version.
  4. All disconnected modules and devices are reconnected securely.
  5. This entire procedure has been reviewed before proceeding.

Do not reprogram the SDM unless directed by a service procedure or a service bulletin.

NOTE:
  • The air bag indicator light may remain ON after the body control module (BCM), or SDM is replaced, and during the programming procedure for the BCM until after the procedure is completed. When installing a new SDM, there may be several DTCs set prior to programming. Once programmed, these DTCs should be in history and can be cleared.
  • Failure to complete the following Setup procedure may cause DTC B1001 to be set in the SDM.

The following service procedures require either a programming or a setup event performed for a complete repair:

scientia non olet · About LEMON Manuals