Removal Procedure
- Relieve the fuel system pressure.
- Remove the retainer from the fuel feed quick-connect fitting.
- Using compressed air, blow any dirt or debris from around the fitting.
- Using the correct tool from the J 37088-A fuel line disconnect tool set , insert the tool into the female connector, then push inward in order to release the quick connect locking tabs.
- Pull the fuel line connection apart.
- Use a clean shop towel in order to wipe off the male pipe end.
- Inspect both ends of the fitting for dirt and burrs. Clean or replace the components, as required.
WARNING:
Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.
CAUTION:
If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.