Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor Replacement

Removal Procedure




1. Remove the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement Exhaust Manifold Lower Heat Shield Replacement.

2. Disconnect the engine wiring harness electrical connector (3) from the crankshaft position (CKP) sensor (4).




3. Remove the crankshaft sensor bolt.

4. Remove the crankshaft sensor.

Installation Procedure




1. Install the crankshaft position sensor.

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the crankshaft position sensor bolt and tighten to 10 Nm (89 lb in).




3. Connect the engine wiring harness electrical connector (3) to the CKP sensor (4).

4. Install the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement Exhaust Manifold Lower Heat Shield Replacement.