Installation Procedure
- Position the fuel feed and EVAP pipes to the vehicle individually, and install the plastic retainers to the marked locations. Tighten the fuel feed/EVAP pipe clip (4) bolt to 8 N.m (71 lb in).
- Install the fuel feed/EVAP pipe clip (2) and nut (3) to the stud and tighten to 9 N.m (80 lb in).
- Install the fuel feed/EVAP pipe clip (1) to the body.
- Connect the EVAP canister vent front pipe quick connect fitting (5) to the chassis EVAP pipe. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel pump fuel feed pipe quick connect fitting (6) to the chassis fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service .
- Install the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement .
- Remove the caps from the fuel rail and the EVAP purge solenoid.
- Connect the EVAP pipe (3) quick connect fitting to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel feed pipe (2) quick connect fitting to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
- Tighten the fuel fill cap.
- Use the following procedure in order to inspect for leaks:
- Turn the ignition ON, with the engine OFF, for 2 seconds.
- Turn the ignition OFF for 10 seconds.
- Turn the ignition ON, with the engine OFF.
- Inspect for fuel leaks.
- Reconnect the brake pressure modulator valve from the body to provide clearance for the fuel pipes. Refer to Brake Pressure Modulator Valve Replacement
- Install the air cleaner assembly. Refer to Fuel Injector Sight Shield Replacement .
- Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
CAUTION:
Refer to Fastener Caution