Removal Procedure
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Without CH-48027) , Fuel Pressure Relief (CH-48027) , Fuel Pressure Relief (High Side) .
- Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
- Remove air cleaner assembly. Refer to Fuel Injector Sight Shield Replacement .
- Disconnect the brake pressure modulator valve from the body to provide clearance for the fuel pipes. Refer to Brake Pressure Modulator Valve Replacement
- Disconnect the fuel feed pipe (2) quick connect fitting from the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
- Disconnect the evaporative emission (EVAP) pipe (3) quick connect fitting from the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
- Cap the fuel rail and the EVAP purge solenoid in order to prevent possible fuel and/or EVAP system contamination.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement .
- Disconnect the fuel pump fuel feed pipe quick connect fitting (6) from the chassis fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service .
- Disconnect the EVAP canister vent front pipe quick connect fitting (5) from the chassis EVAP pipe. Refer to Plastic Collar Quick Connect Fitting Service .
- Remove the fuel feed/EVAP pipe assembly clip (1) from the body.
- Remove the fuel feed/EVAP pipe assembly clip nut (3) and clip (2) from the stud.
- Loosen the fuel feed/EVAP pipe clip (4) bolt, and remove the fuel feed/EVAP pipe assembly from the vehicle.
- Mark the location of the retainers on the new pipes and remove the plastic retainers from the old pipes using a soapy solution.