Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The air bag indicator light may remain ON after the body control module (BCM), or inflatable restraint sensing and diagnostic module (SDM) is replaced, and during the programming procedure for the BCM until after the procedure is completed. When installing a new SDM, there may be several DTCs set prior to programming. Once programmed, these DTCs should be in history and can be cleared.
- Ignition ON, program the SDM. Refer to Service Programming System (SPS) .
- In the Inflatable Restraint Sensing and Diagnostic Module, Configuration / Reset Functions menu, select Setup SDM Part Number in BCM. Follow the scan tool on screen instructions.
- In the Inflatable Restraint Sensing and Diagnostic Module, Configuration / Reset Functions menu, select Configure New Module. Follow the scan tool on screen instructions. If during this procedure a fault is detected, the SDM will not allow this procedure to complete. Repair any existing DTCs, then use the scan tool to command the Configuration / Reset Function again.
- Cycle the ignition from OFF to ON. Verify no DTCs are set. If any DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .