LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Object Detection System) >> Repair Instructions >> Rear Object Sensor Housing Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Object Sensor Housing Replacement

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear fascia. Refer to Rear Bumper Fascia Replacement .
    2. Fig 1: Identifying Rear Object Sensor Housing
    GM1699865Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the sensor harness.
  3. Remove the sensor from the sensor housing.

    The sensor housing must be painted if replaced. If reinstalled, painting will not be necessary.

    4. Fig 2: Illustrating Sanding/Grinding Sonic Weld Plastic Residue From Fascia
    GM1699859Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do Not grind off alignment tabs.
  4. Sand/grind sonic weld plastic residue from the fascia.
    5. Fig 3: Applying Structural Adhesive Epoxy To Fascia
    GM1699866Courtesy of GENERAL MOTORS CORP.
  5. Apply structural adhesive epoxy, Lord Fusor™ 127EZ or equivalent, to fascia at mating surface.
    6. Fig 4: Identifying Sensor Housing & Tabs
    GM1699868Courtesy of GENERAL MOTORS CORP.
  6. Using the alignment tabs, install the sensor housing to the fascia.
  7. Allow adhesive to cure according to manufacturer's directions.
    8. Fig 5: Identifying Rear Object Sensor Housing
    GM1699865Courtesy of GENERAL MOTORS CORP.
  8. Install the sensor to the sensor housing.
  9. Connect the electrical harness.
  10. Install the rear fascia. Refer to Rear Bumper Fascia Replacement .
scientia non olet · About LEMON Manuals