LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the power steering cooler pipe to the vehicle.
    2. Fig 1: View Of Power Steering Gear Outlet Hose Bracket Bolt
    GM1870064Courtesy of GENERAL MOTORS COMPANY
  2. Install a new power steering cooler pipe clamp (2).
  3. Connect the power steering cooler pipe to the power steering gear outlet hose (4,3).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the power steering gear outlet hose bracket bolt (1) and tighten to 8 N.m (71 lb in).
    5. Fig 2: Identifying Power Steering Fluid Cooler, Power Steering Cooler Pipe & Clamp
    GM1870063Courtesy of GENERAL MOTORS COMPANY
  5. Connect the power steering cooler pipe (3) to the power steering fluid cooler (1) and tighten the power steering cooler pipe clamp (2).
  6. Clean any excess fluid from the vehicle and remove the drain pans.
  7. Install the right front frontwards wheelhouse liner. Refer to Front Wheelhouse Front Liner Replacement (Enclave - Acadia) , Front Wheelhouse Front Liner Replacement (Traverse) .
  8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals