LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Volt >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> Body Control Module Programming and Setup >> Replace and Program ECU
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Replace and Program ECU

To program a replacement body control module (BCM), perform the following procedure:

  1. Install EL-49642  SPS programming support tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select BCM Body Control Module - Programming and follow the on-screen instructions.
  4. Place the key in the programming slot. Refer to the Help selection button on the SPS Immobilizer Setup screen for the exact slot location. All additional keys must be at least 3 meters away from the vehicle. When replacing a BCM and adding a new key, always program the existing key first before programming the new key.
    5. NOTE:

    The following programming step may take between 10-12 min. and progress will appear to have stopped during this process. This is a normal security timer response and a restart should not be performed. If the DTC B389A set immediately after programming a replacement BCM, the Immobilizer Learn procedure was not properly completed. The Immobilizer Learn procedure needs to be performed again.

  5. On the SPS Supported Controllers screen, select IMMO Immobilizer Learn - Setup. On the next screen, select Body Control Module IMMO Learn with Existing Transponder or Remote Key and follow the on-screen instructions. When Immobilizer Learn is complete, press the Unlock button on the keyless entry transmitter to allow the keyless entry transmitter to exit the Immobilizer Learn mode.
    6. NOTE:

    When performing the Tire Pressure Monitor Sensor Learn during BCM setup, the EL-46079  tire pressure monitor diagnostic tool must be used to activate each tire pressure sensor.

  6. On the SPS Supported Controllers screen, select BCM Body Control Module - Setup and follow the on-screen instructions.
  7. Check the driver information center display for additional messages regarding further calibration instructions. If there are no additional driver information center instructions present, programming is complete.
  8. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
scientia non olet · About LEMON Manuals