Replace and Program EBCM or Reprogram EBCM

To program a replacement or an existing electronic brake control module, perform the following procedure:

1. Install EL-49642  SPS programming support tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select Electronic Brake Control Module-Programming and follow the on-screen instructions.
4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
5. If the EBCM was replaced and the hydraulic brake lines were disconnected, perform the Antilock Brake System Automated Bleed prior to following the last three steps.
6. With a scan tool access the Electronic Brake Control Module, Configuration/Reset Functions, Electronic Brake Control Module Learn.
7. With a scan tool, access the Electronic Brake Control Module, Configuration/Reset Functions, Brakes Control Offset Learn.
8. With a scan tool, access the Multi-Axis Acceleration Sensor Module, Configuration/Reset Functions, Yaw Rate Sensor Learn.