Fuel Pump Control Module Programming
To program and setup an existing or new replacement fuel pump control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select FPCM Fuel Pump Flow Control Module - Programming and follow the on-screen instructions.
If the fuel pump control module fails to accept the program, verify all scan tool and fuel pump control module connections are secure.
NOTE:
After programming is completed, perform the following to avoid future misdiagnosis:
- Turn the Vehicle OFF for 10 seconds.
- Open and close the door.
- Connect the scan tool to the data link connector.
- Vehicle in Service Mode, engine OFF.
- Clear all DTC's from all modules.