Replace and Program Steering Column Lock Control Module

To program a replacement steering column lock control module, perform the following procedure:

1. Install EL-49642  SPS programming support tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select Steering Column Lock Control Module - Programming and follow the on-screen instructions.
4. On the SPS Supported Controllers screen, select Steering Column Lock Control Module - Setup and follow the on-screen instructions.
5. On the SPS Supported Controllers screen, select Steering Column Lock Control Module - Configuration and follow the on-screen instructions.
6. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.