LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Volt >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Brake Control Brake Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Brake Control Brake Pedal Position Sensor
    GM2634921Courtesy of GENERAL MOTORS COMPANY
  1. Align the locating pin on the brake control brake pedal position sensor (1) to the hole on the brake pedal assembly bracket.
  2. Ensure the brake control brake pedal position sensor fork is properly located on the brake pedal pin.
    3. Fig 2: Brake Control Brake Pedal Position Sensor
    GM2634918Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the brake control brake pedal position sensor bolt (1) and tighten to 9 N.m (80 lb in).
  4. Connect the brake control brake pedal position sensor electrical connector.
  5. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals