Circuit/System Verification

C0475 00

1. Vehicle OFF, disconnect the X2 harness connector at the K43 power steering control module.
2. Test for less than 1 Ω between the ground circuit terminal 1 and ground.
   • If greater than the specified range, test the ground circuit for an open/high resistance.
3. Vehicle in Service Mode, verify that a test lamp illuminates between the B+ circuit terminal 2 and ground.
   • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
4. If all circuits test normal, replace the K43 power steering control module.

C0475 59 

Verify that DTC C0475 59 is not set.

• If the DTC is set, replace the K43 power steering control module.