Rear Camber Adjustment

Special Tools 

EN-45059  Angle Meter

Fig 1: Lower Control Arm Cam
Courtesy of GENERAL MOTORS COMPANY
1. Loosen the lower control arm cam bolt nuts.
2. Rotate the cam bolts to the required camber specification setting. Refer to Wheel Alignment Specifications .
CAUTION:

Refer to Fastener Caution .

NOTE:

Maintain the camber setting while tightening the cam bolt nuts.

3. Tighten the rear lower control arm (front) nut to 170 N.m (125 lb ft).
4. Using the EN-45059  meter and a torque wrench, tighten the nuts to:

   Tighten 

   • First Pass: 60 N.m (44 lb ft)
   • Final Pass: plus 60 degrees
NOTE:

Check the toe setting AFTER changing camber or caster.

5. Check the camber setting after tightening.

   Adjust the camber setting if necessary.