Replace and Program EBCM or Reprogram EBCM

To program a replacement or an existing EBCM, perform the following procedure:

1. Install EL-49642  SPS Programming Support Tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select Electronic Brake Control Module-Programming and follow the on-screen instructions.
4. On the SPS Supported Controllers screen, select Electronic Brake Control Module- Setup and follow the on-screen instructions.
5. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
6. With a scan tool access the EBCM, Configuration/Reset Functions, Electronic Brake Control Module Learn.