Installation Procedure

Fig 1: Installing BCM Into Bracket

Courtesy of GENERAL MOTORS COMPANY

Install the BCM (1) into the bracket.
Ensure the BCM (1) is engaged in the bracket, under the retaining tabs (2).

Fig 2: Electrical Connectors And Body Control Module
Courtesy of GENERAL MOTORS COMPANY
Connect the electrical connectors (2) to the BCM (1).

Fig 3: Identifying Right Side Knee Bolster Trim Panel
Courtesy of GENERAL MOTORS COMPANY
Install the right side knee bolster trim panel. Refer to Passenger Knee Bolster Replacement .
If you replaced the BCM, program the module. Refer to Body Control Module Programming and Setup .
Refer to Control Module References for programming and setup information.