Steering Gear Boot Replacement (NJ2)
Courtesy of GENERAL MOTORS COMPANY Steering Gear Boot Replacement (NJ2)
| Callout |
Component Name |
|
Preliminary Procedures
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
- Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
|
| 1 |
Steering Linkage Inner Tie Rod Nut |
| 2 |
Steering Gear Boot Outer Clamp |
| 3 |
Steering Gear Boot Inner Clamp Procedure
- Cut the steering gear boot inner clamp. Discard the clamp.
- Use the CH-22610
pliers to install a NEW steering gear boot inner clamp.
Special Tools
CH-22610
Pliers
For equivalent regional tools, refer to Special Tools . |
| 4 |
Steering Gear Boot Procedure
- After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear. Refer to Electric Belt Drive Rack and Pinion Steering Gear Replacement (LFX, M7W, NJ2) .
- Apply a small amount of Lithium Grease or equivalent to the inside of both ends of the steering gear boot. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the steering gear boot and ensure the boot is seated in the assembly groove of the steering gear before installing the steering gear boot clamps.
|
| 5 |
Steering Gear Boot Seal |