Rear Toe Adjustment
- Measure the alignment on an alignment rack. Refer to Wheel Alignment Measurement .
- If adjustment is necessary, remove rear cam bolt and nut. Replace with NEW only.
- Rotate the cam nut in order to adjust the toe angle. Refer to Wheel Alignment Specifications .
- Hand tighten the cam bolt, but do not tighten the bolt to the specification yet.
- Re-inspect the rear toe angle and adjust as necessary.
- Hold the cam bolt and tighten the cam nut.
Tighten
- First pass : 90 ( 66 lb ft )
- Final pass : plus 60 degrees
- Repeat the procedure for the other rear wheel.
- Lower the vehicle.
NOTE:
Do not tighten the new fasteners yet in order to allow for movement.
CAUTION:
Refer to Fastener Caution .