Removal Procedure

CAUTION:

To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.

Fig 1: Electronic Brake Control Module

Courtesy of GENERAL MOTORS COMPANY

Thoroughly clean the area around the electronic brake control module (EBCM) of all dirt and debris.
Disconnect the EBCM electrical connector.
Remove the EBCM bolts (1).

Fig 2: EBCM & Brake Pressure Modulator Valve

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Do not attempt to pry or lever against the EBCM.

Carefully separate the EBCM (1) from the brake pressure modulator valve (BPMV) by pulling straight away from the BPMV.
Do not force the components apart.