Installation Procedure
- Install the battery positive cable (1) to the passthrough stud and tighten the fastener (2) to 15 (11 lb ft).
- Install the protective cover (3).
- Install the battery positive cable retainers (1) to the floor panel tunnel.
- Route the battery positive cable (2) along the body harness conduit and attach the battery positive cable retainers (1).
- Slide the battery positive cable (2) into the rear compartment area and attach the battery positive cable retainers (1) to the body harness conduit.
- Connect the battery positive cable (2) to the battery and tighten the clamp fastener (1) to 5 (44 lb in).
- Install the battery positive cable cover (5).
- Connect the battery positive cable connector (3) to the body harness connector (4).
- Connect the battery positive cable connector (2) to the accessory relay block (1).
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Install the rear compartment side trim panel. Refer to Rear Compartment Side Trim Panel Replacement (Left Side) , Rear Compartment Side Trim Panel Replacement (Right Side) .
- Install the rear compartment floor panel carpet. Refer to Rear Compartment Floor Panel Carpet Replacement .
- Install the rear seat cushion. Refer to Rear Seat Back Cushion Removal and Installation (Split Folding Side Cushion Sedan) , Rear Seat Back Cushion Removal and Installation (Split Folding Center Cushion Sedan) , Rear Seat Back Cushion Removal and Installation (Fixed Back) .
- Install the passenger front seat. Refer to Driver or Passenger Seat Removal and Installation .
CAUTION:
Refer to Fastener Caution .