LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> SS >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.2L (LS3) - Repair Instructions >> Repair Instructions >> Filler Tube Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the fuel filler tube to the vehicle.
    2. Fig 1: Fuel Tank Neck Retaining Clamp
    GM1949799Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the fuel filler tube to fuel tank neck retaining clamp (1).

    Tighten 

    Tighten the clamp to 3.5 N.m (31 lb in).

  3. Connect the fuel filler vent tube (2) to the fuel tank. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 2: Chassis Retaining Bolts
    GM1949801Courtesy of GENERAL MOTORS COMPANY
  4. Install the fuel filler tube to chassis retaining bolts (1).

    Tighten 

    Tighten the bolts to 9 N.m (80 lb in).

    5. Fig 3: Earth Lead Connector
    GM1949800Courtesy of GENERAL MOTORS COMPANY
  5. Install the fuel filler tube to upper fuel filler neck rubber seal surround.
  6. Install the earth lead connector (2) to upper filler neck.
  7. Install the rear wheelhouse liner. Refer to Rear Wheelhouse Liner Replacement .
  8. Install the rear bumper fascia. Refer to Rear Bumper Fascia Replacement .
  9. Install the right rear wheel. Refer to Tire and Wheel Removal and Installation .
  10. Add fuel to the fuel tank.
  11. Inspect for fuel leaks.
  12. Install the fuel filler cap.
scientia non olet · About LEMON Manuals