LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Spark LS, Standard Trans >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Boot Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Steering Gear Boot
    GM2028058Courtesy of GENERAL MOTORS COMPANY
  1. Install a new clamp (2) loosely on the inner part of the steering gear boot.
  2. Apply grease from the service kit to the indicated locations.
    3. NOTE:

    The steering gear boot must seat in the appropriate groove on the steering gear.

  3. Install the steering gear boot (1) over the steering linkage inner tie rod and onto the steering gear.
    4. Fig 2: Steering Gear Inner Boot Clamp
    GM2028057Courtesy of GENERAL MOTORS COMPANY
  4. Using CH-804  pliers crimp the inner steering gear boot clamp (1).
    5. Fig 3: Steering Linkage Inner Tie Rod Nut
    GM2028056Courtesy of GENERAL MOTORS COMPANY
  5. Install the steering gear outer boot clamp (2).
  6. Install the steering linkage inner tie rod nut (1).
  7. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
scientia non olet · About LEMON Manuals