Replace and Program Control Module

To program a replacement engine control module (ECM), perform the following procedure:

1. Install EL-49642  SPS Programming Support Tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select Engine Control Module - Programming and follow the on-screen instructions.
4. On the SPS Supported Controllers screen, select Engine Control Module - Setup and follow the on-screen instructions.
5. On the SPS Supported Controllers screen, select Engine Control Module - Configuration and follow the on-screen instructions.
6. On the SPS Supported Controllers screen, select Engine Function - Learn/Setup and follow the on-screen instructions.
7. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
8. With a scan tool, perform the Theft Deterrent Programming procedure. Refer to Immobilizer System Component Programming (without BTM)Immobilizer System Component Programming (with BTM) .
9. With a scan tool, perform the CKP System Variation Learn procedure. Refer to Crankshaft Position Reluctor Wheel Learn .
10. With a scan tool, perform the Diesel Particulate Filter (DPF) Service Regeneration Enable procedure. Refer to Diesel Particulate Filter (DPF) Regeneration Enable .
11. With a scan tool, reset the Engine Oil Life Remaining back to the original percentage recorded before the control module was replaced, if available.