Removal Procedure
- Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
- Remove the steering linkage inner tie rod nut (1) from the steering linkage inner tie rod.
- Remove the steering gear boot outer clamp (2).
- Remove the steering gear boot inner clamp (1). DISCARD the clamp.
- Remove the steering gear boot (2) from the steering gear.
- Inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear. Refer to Electric Belt Drive Rack and Pinion Steering Gear Replacement .
- Remove the steering gear boot seal (1) from the steering gear housing.
NOTE:
Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod to mark the location of the nut on the inner tie rod.