Replace and Program Control Module

Do not reprogram the front view camera module, unless directed by a service procedure, or a service bulletin.

To program a replacement or an existing front view camera module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K109 front view Camera Module - Programming and follow the on-screen instructions.
3. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
4. Following K109 front view Camera Module programming, the module must be calibrated. Refer to Front View Camera Module Calibration .