Replace and Program Steering Column Lock Control Module or Reprogram Steering Column Lock Control Module
NOTE:
To ensure that the steering column lock password from the BCM is learned: turn ignition ON and then OFF, close all doors and wait 5 minutes.
To program a replacement steering column lock control module or reprogram an existing steering column lock control module, perform the following procedure:
- Install EL-49642 SPS programming support tool.
- Ignition ON.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Steering Column Lock Control Module - Programming and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.