Remote Control Door Lock and Theft Deterrent Transmitter Programming (with BTM): Notes

Transmitters can be programmed in various ways using the adding or replacing keys procedures outlined below. The transmitter with the key blade installed is required for programming.

Using the Replacing Keys procedures will first erase all the known keys from the vehicle. Any existing keys and any new keys will then be programmed. This procedure is typically used any time a key is required to be unlearned or erased from a vehicle. If a new key is being learned to a vehicle to replace a damaged, inoperative or stolen key, the Replacing Keys procedure is often used. This ensures that the old key cannot be used to access or start the vehicle after programming.

The Adding Keys procedure does not erase any keys prior to programming. The procedure will simply program the key into the next available slot. The Adding Keys procedure should be used when adding an additional key to the vehicle.