LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Cruze LS, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.4L (LE2) - Repair Instructions >> Repair Instructions >> Fuel Injection Fuel Rail Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: Refer to Gasoline/Gasoline Vapors Warning .
WARNING: Refer to Safety Goggles and Fuel Warning .
CAUTION: When working on the fuel rail and fuel injectors, always maintain a clean work surface. Failure to maintain a clean work surface can result in contaminant on the injector seals and cause leaks.
  1. Remove the fuel injection fuel rail assembly. Refer to Fuel Injection Fuel Rail Assembly Removal and Installation .
  2. Remove the 8 plate bolts (1) and remove the EN-51146-1-2  plate (2), counterhold with a wrench (4) at the EN-51146-1-1  supports (3).
    Fig 1: Plate, Bolts And Supports
    GM2918404Courtesy of GENERAL MOTORS COMPANY
    NOTE: The EN-51146-2-5  calibrations tools must be installed.
  3. Remove the 8 EN-51146-1-1  supports (3).
  4. Disconnect the 4 fuel injector wiring harness plugs (2).
    Fig 2: Fuel Injection Fuel Rail
    GM2918407Courtesy of GENERAL MOTORS COMPANY
  5. Fuel Injector (3) @ Fuel Injection Fuel Rail (1)» Remove [4x]
  6. O-Ring (1) @ Fuel Injector (2)» Remove and DISCARD
    Fig 3: Fuel Injectors And Seals
    GM3216232Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals