Removal Procedure
WARNING:
Refer to Brake Dust Warning .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Disconnect the rear wheel speed sensor electrical connector and release the harness clips (1).
- Release the wheel speed sensor harness from the clip (1) on the rear suspension knuckle.
- Clean the wheel speed sensor area on the suspension knuckle of any accumulated dirt and debris.
- Remove the wheel speed sensor bolt (1).
- Remove the wheel speed sensor assembly from the suspension knuckle by pulling straight out.