Replace and Program Control Module

To program a replacement control module, perform the following procedure:

1. Install EL-49642  SPS programming support tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select Hybrid Powertrain Control Module 2 - Programming and follow the on-screen instructions.
4. At the end of programming, choose the "Clear All DTCs"
5. With a scan tool, perform the Hybrid/EV Battery Pack Capacity Learn and follow the on-screen instructions.
6. With a scan tool, select Hybrid/EV Powertrain Control Module 2 Configuration/Reset Functions. Perform the Learn Functions - Hybrid/EV Battery Pack Charging Adaptive Learn Reset and follow the on-screen instructions.
7. With a scan tool, perform the Hybrid/EV Battery Pack Coolant Control Valve Learn and follow the on-screen instructions.
8. With a scan tool, perform the Clear Secured High Voltage DTCs and follow the on-screen instructions.
9. With a scan tool, Clear All DTCs.