TCM Reprogramming
- If the TCM needs to be programmed. Refer to Service Programming System (SPS) .
- Perform the Transmission Service Fast Learn. Refer to Transmission Service Fast Learn Procedure (MR8) .
NOTE:
Use a scan tool to view and record the Transmission Control Module - End Model Part Number in the original TCM prior to starting the TCM programming procedure.
- Turn the ignition OFF for 30 seconds.
- Turn the ignition ON with the engine OFF.
- Use the scan tool in order to retrieve history DTCs from all modules.
- Clear all history DTCs.
NOTE:
After programming, perform the following to avoid future misdiagnosis: