Removal Procedure
WARNING:
WARNING:
- Remove Fuel Tank Replacement
- Remove Fuel Feed Pipe Replacement - Fuel Pump Module to Underbody
- Disconnect Electrical Connector (1)
- Disconnect the evaporative emission canister vent pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
- Install the CH-45722 Main Fuel Pump Locking Ring Remover/Installer (1) to the fuel pump module lock ring (2).
- Using the CH-45722 Main Fuel Pump Locking Ring Remover/Installer (1) and a long breaker-bar, rotate the lock ring in a counterclockwise direction in order to unlock the lock ring.
- Remove the CH-45722 Main Fuel Pump Locking Ring Remover/Installer (1).
- Remove the fuel tank pump module locking ring (1).
- Remove Fuel Tank Fuel Pump Module (2)
- Remove and DISCARD the fuel pump module seal (3).
- Remove Fuel Level Sensor Replacement
- Remove Fuel Tank Pressure Sensor Replacement
NOTE:
DO NOT use impact tools. Significant force will be required to release the lock ring. The use of a hammer and screwdriver is not recommended. Secure the fuel tank in order to prevent fuel tank rotation.
NOTE:
Lift the fuel tank fuel pump module up slightly. Pay attention to the fuel level sensor.