Circuit/System Testing

NOTE:

Circuit/System Verification must be performed before Circuit/System Testing.

Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the S148E Multifunction Switch - Center Console. It may take up to 2 min for all vehicle systems to power down.
Test for less than 5 Ω between the ground circuit terminal 9 and ground.
- If 5 Ω or greater
1. Ignition OFF.
2. Test for less than 2 Ω in the ground circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, repair the open/high resistance in the ground connection.
- If less than 5 Ω
Ignition ON.
Verify the scan tool Body Control Module Traction Control Switch parameter is Inactive.
- If not Inactive
1. Ignition OFF, disconnect the X2 harness connector at the K9 Body Control Module.
2. Test for infinite resistance between the signal circuit terminal 14 and ground.
  - If less than infinite resistance, repair the short to ground on the circuit.
  - If infinite resistance, replace the K9 Body Control Module.
- If Inactive
Install a 3 A fused jumper wire between the signal circuit terminal 5 and ground circuit terminal 9.
Verify the scan tool Traction Control Switch parameter is Active.
- If not Active
1. Ignition OFF, disconnect the X2 harness connector at the K9 Body Control Module, ignition ON.
2. Test for less than 1 V between the signal circuit and ground.
  - If 1 V or greater, repair the short to voltage on the circuit.
  - If less than 1 V
3. Test for less than 2 Ω in the signal circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, replace the K9 Body Control Module.
- If Active
Test or replace the S148E Multifunction Switch - Center Console.