Removal Procedure
WARNING:
Refer to Brake Dust Warning .
- From inside the engine compartment, disconnect the front wheel speed sensor electrical connector.
- Feed the wheel speed sensor electrical connector and harness through the wheel house panel closeout.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Release the wheel speed sensor harness grommets (1) from the brake hose bracket and the suspension strut.
- Release the wheel speed sensor harness from the clip (1) on the suspension strut.
- Clean the wheel speed sensor area on the steering knuckle of any accumulated dirt and debris.
- Remove the wheel speed sensor bolt (1).
- Remove the wheel speed sensor assembly from the steering knuckle by pulling straight out.