LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> SS Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.2L (LS3) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: CMP Sensor, O-ring & Bolt
    GM3292850Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install a NEW O-ring to the camshaft sensor

    NOTE:

    Before installing the camshaft sensor, apply a small amount of clean motor oil to the O-ring (3).

  1. Install a NEW O-ring (3) to the CMP sensor.
  2. Install the CMP sensor (2) to the engine front cover.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the CMP sensor to engine front cover retaining bolt (1) and tighten to 9 N.m (80 lb in).
    4. Fig 2: Camshaft Position Sensor Electrical Connector
    GM3292851Courtesy of GENERAL MOTORS COMPANY
  4. Connect the CMP sensor electrical connector (1) to wiring harness.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  6. Connect the battery ground cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
  7. If re-programming is required, refer to Control Module References .
scientia non olet · About LEMON Manuals