Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing control module, perform the following procedure:

1. Install EL-49642  SPS Programming Support Tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K109 Frontview Camera Module- Programming and follow the on-screen instructions.
4. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Setup and follow the on-screen instructions. Refer to Front View Camera Module Learn .
5. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.