Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful programming event, perform the following steps:

1. Ignition ON. Ensure the control module, DLC and programming tool connections are secure and the SPS software is up to date.
2. Verify the front view control module can be reprogrammed.
   • If the front view control module cannot be reprogrammed 
   1. Ignition OFF for one minute, ignition ON.
   2. Verify the front view control module can be reprogrammed.
      • If the front view control module cannot be reprogrammed, replace the control module.
      • If the front view control module can be reprogrammed.
   3. All OK.
   • If the front view control module can be reprogrammed 
3. All OK.