Front View Camera Module Replacement

To program a replacement of the Front View Camera Module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.
3. If reprogramming an existing module that was previously calibrated, calibration is not required. The module retains its calibration settings during reprogramming. If a new module was programmed the module alignment must be calibrated. Using a scantool, initiate the learn procedure for Frontview Camera Module. The scantool must remain connected and on the calibration screen during the entire process.
   NOTE: After programming is performed, it is normal to have DTC B101E 4B set until calibration is complete.

   Refer to Front View Camera Module Learn .