Parking Assist Sensor Learn Calibration: Calibration

The calibration process for the Parking Assist system is necessary when a parking assist sensor has been replaced or improperly learned.

To calibrate the Parking Assist sensors:

1. Select Parking Assist Sensor Learn  in the scan tool
   NOTE: Parking Assist Sensors should be at or near room temperature
2. Operate the vehicle in the following conditions until the calibration is complete:
   • Nothing is within 50cm of the parking assist sensors
   • Ensure the parking assist sensors are clean
3. Vehicle OFF, scan tool disconnected, all doors closed, all accessories OFF, open and close driver door. It may take up to 2 min for all vehicle systems to power down.
4. Verify Parking Assist system is operating correctly and there are no DTCs set.