Circuit/System Verification
- Ignition ON/Vehicle In Service Mode.
- Verify that DTC U0073, U0074, U0075, U0077, U0078, U007A, P06E4, P1EB9, U1814, U2099, B1325, B1330, B1370, B1380, B1424, B1428, B1440, B1441, B1517, C0800, C0899, C12E1, P0560, or P0562 is not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs are set
- If any of the DTCs are set
- Attempt to communicate with all devices on the gateway isolated low speed GMLAN serial data circuit. Refer to Data Link References to determine which devices are on the gateway isolated low speed GMLAN bus.
- Verify that all gateway isolated low speed GMLAN devices are communicating.
- If only one device is not communicating
Refer to Circuit/System Testing - Testing the Device Circuits.
- If all devices are not communicating, except the K56 Serial Data Gateway Module
Refer to Circuit/System Testing.
- If two or more devices are not communicating but not all, except the K56 Serial Data Gateway Module
Refer to Circuit/System Testing - Testing the Serial Data Circuits for an Open/High Resistance.
- If all devices are communicating
- If only one device is not communicating
- All OK.