Removal Procedure
Refer to Brake Fluid Irritant Warning .
Refer to Brake Fluid Effects on Paint and Electrical Components Caution .
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
- Turn the ignition switch to the OFF position.
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
- Disconnect the electronic brake control module (EBCM) electrical connector (1) by lifting the locking tabs.
- Disconnect the master cylinder inlet brake pipe fittings (1).
Cap the brake pipe fittings and plug the brake pressure modulator valve (BPMV) inlet ports to prevent brake fluid loss and contamination.
- Disconnect the BPMV outlet port front brake pipe fittings (1).
Cap the brake pipe fittings and plug the BPMV outlet ports to prevent brake fluid loss and contamination.
- Disconnect the BPMV outlet port rear brake pipe fittings (1).
Cap the brake pipe fittings and plug the BPMV outlet ports to prevent brake fluid loss and contamination.
- Remove the 2 BPMV bracket nuts (1).
- Remove the BPMV from the vehicle.
- Remove the 2 BPMV insulator nuts and washers.
- Carefully remove the BPMV from the bracket by pulling upward.
- Remove the 2 BPMV insulators.
Inspect the insulators for damage and replace, if necessary.
- Remove the lower BPMV insulator.
Inspect the insulator for damage and replace, if necessary.