LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Traverse LS Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Front Wheel Speed Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. If replacing the left front wheel speed sensor, remove the air cleaner element. Refer to Air Cleaner Element Replacement .
  2. If replacing the right front wheel speed sensor, disconnect and position aside the battery positive junction block cables. Refer to Battery Positive Junction Block Cable Replacement .
    3. Fig 1: Wheel Speed Sensor Electrical Connector
    GM1861959Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the wheel speed sensor electrical connector (1).
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    6. Fig 2: Wheel Speed Sensor Wire, Wire Grommet, Connector & Harness Routing Clips
    GM1861960Courtesy of GENERAL MOTORS COMPANY
  6. Release the wheel speed sensor wire grommet (1) from the wheelhouse.
  7. Carefully pull the wheel speed sensor wire and connector (2) through the wheel house.
  8. Release the wheel speed sensor wire harness routing clip (3) from the wheel house.
  9. Release the wheel speed sensor wire harness routing clips (4) and (5) from the suspension strut.
    10. Fig 3: Wheel Speed Sensor Bolt
    GM1861961Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Clean the wheel speed sensor mounting area on the steering knuckle of any accumulated dirt and debris.

  10. Remove the wheel speed sensor bolt.
  11. Pull the wheel speed sensor straight up and out of the steering knuckle.
scientia non olet · About LEMON Manuals