LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Traverse LS Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: CMP Sensor Bolt & Sensor - Bank 2 (Left Side) Intake
    GM1860459Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the CMP sensor (3) and bolt.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

    2. Fig 2: Intake & Exhaust Camshaft Position (CMP) Sensors - Bank 2 (Left Side) Intake
    GM1860429Courtesy of GENERAL MOTORS COMPANY
  2. Connect the engine wiring harness electrical connector (8) to the bank 2 intake CMP sensor (7).
    3. Fig 3: Remote Power Steering Fluid Reservoir, Bracket & Bolts - Bank 2 (Left Side) Intake
    GM1856014Courtesy of GENERAL MOTORS COMPANY
  3. Install Power Steering Fluid Reservoir Bracket (2) - Power Steering Fluid Reservoir Bracket Replacement
  4. Install the radiator inlet hose to the water outlet. Radiator Inlet Hose Replacement
  5. Install the engine mount strut bracket. Engine Mount Strut Bracket Replacement - Right Side
scientia non olet · About LEMON Manuals