Installation Procedure
- Install the fuel tank fill hose (1), if necessary.
- Tighten the fuel tank fill hose clamp (2), if necessary.
Tighten
Tighten the clamp to 3.3 N.m (29 lb in).
- Position and install the fuel tank fill hose (2) to the fuel tank.
- Connect the evaporative emission (EVAP) canister vent rear pipe quick connect fitting (4) to the recirculation line on the fuel tank fill pipe (3). Refer to Plastic Collar Quick Connect Fitting Service .
- Tighten the fuel tank fill hose clamp (1) at the fuel tank.
Tighten
Tighten the clamp to 3.3 N.m (29 lb in).
- Install the fuel tank fill pipe bracket bolt (2).
Tighten
Tighten the bolt to 12 N.m (106 lb in).
- Install the left rear wheelhouse liner panel. Refer to Rear Wheelhouse Liner Replacement (Traverse)Rear Wheelhouse Liner Replacement (Enclave)Rear Wheelhouse Liner Replacement (Acadia) .
- Install the left rear wheel and tire. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Install the fuel tank fill pipe housing to fuel tank fill pipe bolts (1).
Tighten
Tighten the bolts to 2 N.m (18 lb in).
- Install the fuel fill cap.
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure that the notch in the fill hose aligns with the tab on the fuel tank.