LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Traverse LS Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

CAUTION:

Refer to Heated Oxygen and Oxygen Sensor Caution .

    Fig 1: Heated Oxygen Sensor Electrical Connector - Bank 1 Sensor 2
    GM1858127Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the connector position assurance (CPA) retainer (4).
  3. Disconnect the heated oxygen sensor (HO2S) electrical connector (6) from the engine wiring harness electrical connector (5).
    4. Fig 2: Heated Oxygen Sensors & Exhaust Manifold - Bank 1 Sensor 2
    GM1858130Courtesy of GENERAL MOTORS COMPANY
  4. Remove the HO2S (3) from the exhaust pipe.
scientia non olet · About LEMON Manuals